~A great deal of energy is necessary to sublimate snow to water vapor.
~This energy likely creates a shallow cooling layer on top of snow surface, a potential component of air inversions.
~ The process is continuous as long as there is snow, helps explain the 1st rule of sea ice horizon refraction.
The first rule of sea ice horizon refraction may as well be called the first rule of snow covered horizons, a paper from J. W. Pomeroy and E. Brun have directly found top of snow colder than surface air:
Refer to graphs on page 89. Where boreal forest top of ground snow or air slightly above it was always colder than surface air. Although they did not highlight this feature in this paper, this confirms what happens in the Arctic as well. A boreal forest heavily snow clad horizon should be quite similar to sea ice horizons.
Remains to identify the reason or reasons. What creates a skin surface to be colder than either air or what is below a skin surface? It is counter intuitive, but sublimation seems to fit the bill, it happens as long as there is snow, when so there would be an endothermic process involved, which infers a drop in temperature.
Applied on the totally white snow covered Arctic scale, the primary reasons for persistent winter inversions may be caused by the colder ground or sea ice with radiation escaping to space twinned with the sublimation of snow which is a continuous process until the sun is high enough in the sky to warm up top of snow surface, in spite of continuing sublimation, the extra heat compensates and appears to cancel sublimation cooling, triggering an even greater loss of snow cover without outside temperatures being well above 0 C. Since the end of 2017 long night, the Northwest Passage by Cornwallis Island had often a great deal of diurnal ice fog bursts, which may be explained by the presence of significantly above normal snow cover generating more water vapor, sublimating vapor adds to Arctic air bromine chemical mix always capped at the near permanent inversion peak temperature usually varying at about 800 meters in late March early April.
Snow column substitution experiment
A way to separate a possible thermal radiance cooling effect from sublimation would be to remove a portion of the snow column with a body warm enough to affect the snow skin temperature immediately above. I used a 9.3 liter sealed container having a liquid, mainly consisting water, made a cavity once filled with snow, placing the sealed container with +27.7 C liquid within, cover the exposed side of container with snow and measure subdernal skin temperature above an undisturbed 10 cm layer of snow separating the skin and top of container.
A few meters away from this experiment, there was the regular high precision thermistor subdermal measurement which regularly showed a +.4 C skin cooling vs surface air, lower than measurements made March 24 and 31, because it was very windy, high winds above 10 m/s removed all chances of extensive stratification. The subdermal temperatures above the container were always equal or slightly warmer than surface air, the opposite result above a complete snow column. This implies a warmed top snow layer without a skin cooling effect. Snow sublimation was highly likely occurring but the heat supplied by the liquid container overwhelmed the drop in temperature required to vaporize snow, similarly to when the sun is high enough and masks sublimation cooling.
WD April 2-4 2017